|
ENACOM published the Resolution 586, dated May 8, 2023 with Minimum mandatory guidelines for equipment marking. According to the Resolution 586 and further consultation with ENACOM, the new options for label placements are as follows:
1) If due to the structural nature, size or packaging, it is not possible to perform the marking directly on the product. Identification must be printed in the user Manual, and/or the quick start guide and/or corresponding package (either one of them is enough).
2) When the homologated device is installed inside a vehicle (automobiles, watercrafts, aircrafts, motorcycles, etc.) and its regulatory identification is not visible, the Identification must be printed on the product, and at least on one of the other options (in manual and/or in the documentation accompanying vehicle, and/or be published on the official website of the vehicle’s manufacturer or importer). As the marking on the product is mandatory, the old CNC ID marking on the product must be changed to RAMATEL.
3) For e-labeling, the marking must be displayed on the device screens. Instructions for e-label access should be included in the user manual, and/or in the quick start guide (or other documentation accompanying equipment), and/or on the packaging and/or on the official website of the manufacturer or importer (either one of them is enough).
Please refer to the official link of the Resolution as below:
Please feel free to contact us for more details.
2023-07-18
|
Argentina- Minimum mandatory guidelines for equipment marking
